The following projects are based on KK Board. This list shows the latest innovative projects which can be built by students to develop hands-on experience in areas related to/ using KK Board.
CarCoper is the combination the copter and car having the mixture of two technology Automobile technology and Aeronautical Engineering. Car means something mobily On land and copter means having rotational motion in form of propeller. Its really cool to make the combo of car and copter. Something we call as hybrid technology which is which an nully disadvantage of two individual mode by adding the technology.
Read more..
A tricopter consists of three motors, three controllers, one servo and four gyros. The three motors are located at the end of each of the three arms. In addition, there is a location sensor in each case. This gyro controls the controllers, which are located in the fuselage of the aircraft. The motor is therefore nothing but a normal servo in one direction. If we want to lift the tricopter, a movement of the throttle lever is sufficient, the Gyro gets the signal from the receiver and passes it on to the controller – the motors are rotating. This is precisely the difference between a hand-controlled helicopter and a tricopter, because the tricopter stabilizes automatically. Interfering influences such as wind or torque fluctuations are compensated for with the aid of the sensors and the electronics itself – manual correction is not necessary.
Read more..